6000 PSI Needle Valve


  • Bar Stock Body in Straight and Angle Pattern
  • Packing below stem thread to prevents fluid from contacting threads.
  • Anti-Blow Out Stem design.
  • Leak tight seal with Low Operating torque.
  • Lock nut secures packing nut to prohibit accidental removal.
  • Non rotating hardened 17-4 PH material stem tip available on request.
  • Orifice size available in 4.2mm, 6.3 mm and 9.5 mm.
  • All Valves are tested at bubble tight leakage at seat and packing.


Pressure Rating

Upto 10000 PSI

Temperature Rating

PTFE: -65°F to 450°F ( -50°C to 232°C)

Graphite: -65°F to 842°F ( -50°C to 450°C)

End Connection Sizes

1/4” to 1” (BSP, NPT, BSPT Female Thread)


The needle valves are used to accurately control and regulate water flow as well as pressure.

The main difference between these two valves is that the needle valve control flows in both directions while the flow control valve control flows in only one direction.

Needle valves are very similar to the globe valves in design.

A needle valve controls the pressure rather than reducing it.

The main purpose of a needle valve is to control the flow of the liquid or gas and to protect subtitle gauges from the damages such as pressure surges of liquids and gases.